Chlorinated foaming detergent which can be applied on aluminium and other soft metals. Silicates-free product.

Highly effective for removing fatty and protein soils found in industry, leaving surfaces clean, deodorized and bleached.
At the recommended dose, it does not attack aluminium surfaces.
Do not mix with other chemical products. Incompatible with acids and other cleaning products. Do not mix with ammonia, salfumant or acidic cleaners.

Aspect: Transparent liquid
Colour: Slightly yellow
Density at 20ºC: 1,10 g/cc
pH: 13
Solubility: Fully soluble in water
Dose: 1% – 5%

Foam generating equipment: Pre-rinse the surfaces to be cleaned to remove coarse dirt. Apply the product diluted in water between 2,5% and 5%, depending on the present soil. Perfectly cover with foam al surfaces. Leave on for 15 minutes. Rinse with pressurized water.

Manual: Dilute the product from 1% to 3%, depending on the present soil. Use a scouring pad or brush. Rinse.
Immersion: Prepare a dilution of the product between 2% and 5%. Soak the utensils/tools and leave to act for
15 minutes. Remove from the bath and rinse abundantly.

Next, a table is presented where, from the conductivity, the real concentration of the product can be known

Specific Conductivity at 20ºC

See the Product Safety Sheet.
The Raw Materials used comply with the criteria of Sustainable Development promoted by the “Charter Project for Sustainability”.
The surfactants contained in this preparation meet the biodegradability criteria stipulated in regulation (EC) No. 648/2004 on detergents.